CERN Accelerating science

Accelerator Physics

Posledne pridané:
Application of Machine Learning in Beam Optics Measurements and Corrections / Fol, Elena
The present research in high energy physics as well as in the nuclear physics requires the use of more powerful and complex particle accelerators to provide high luminosity, high intensity, and high brightness beams to experiments [...]
CERN-THESIS-2021-261 - 115 p.

Úplný záznam - Podobné záznamy
Machine Learning Techniques for Optics Measurements and Corrections / Fol, Elena (CERN) ; Franchetti, Giuliano (Darmstadt, GSI) ; Tomás García, Rogelio (CERN)
Recently, various efforts have presented Machine Learning (ML) as a powerful tool for solving accelerator problems. In the LHC a decision tree-based algorithm has been applied to detect erroneous beam position monitors demonstrating successful results in operation. [...]
2021 - 6 p. - Published in : JACoW IPAC 2020 (2020) 61-66 Fulltext: PDF;
In : 11th International Particle Accelerator Conference, Caen, France, 10 - 15 May 2020, pp.61-66

Úplný záznam - Podobné záznamy
Recommissioning of the CERN AD Stochastic Cooling System in 2021 after Long Shutdown 2 / Hofle, Wolfgang (CERN) ; Oliveira, Joao Carlos (CERN) ; Carli, Christian (CERN) ; Caspers, Fritz (European Scientific Institute (FR)) ; Dupuy, Bruno (CERN) ; Gamba, Davide (CERN) ; Louwerse, Reinier (CERN) ; Ponce, Laurette (CERN) ; Myklebust, Vebjorn Roed ; Rey, Stephane Franck (CERN) et al.
The power system of the Stochastic Cooling System of the anti-proton decelerator AD at CERN, installed on top of the shielding blocks of the AD ring, was completely dismantled during the long shutdown 2 (LS2) at the end of the 2018 run in order to gain access to the accelerator for magnet consolidation. [...]
CERN-ACC-NOTE-2022-0003 ; ISBN: 978-3-95450-243-1 ; ISSN: 2226-0374 ; doi: 10.18429/JACoW-COOL2021-S302.
- 2022. - 6 p.
Access to fulltext

Úplný záznam - Podobné záznamy
General mitigation techniques for coherent beam instabilities in particle accelerators / Métral, Elias (CERN)
An important number of coherent beam instability mechanisms can be observed in a particle accelerator, depending if the latter is linear or circular, operated at low, medium or high energy, with a small or a huge amount of turns (for circular machines), close to transition energy or not (below or above), with only one bunch or many bunches, with counter-rotating beams (such as in colliders) or not, if the beam is positively or negatively charged, if one is interested in the longitudinal plane or in the transverse plane, in the presence of linear coupling between the transverse planes or not, in the presence of nonlinearities or not, in the presence of noise or not, etc. Building a realistic impedance model of a machine is a necessary step to be able to evaluate the machine performance limitations, identify the main contributors in case an impedance reduction is required, and study the interaction with other mechanisms such as optics (linear and nonlinear), RF gymnastics, transverse damper, noise, space charge, electron cloud, and beam–beam (in a collider). [...]
2021 - 23 p. - Published in : Eur. Phys. J. Plus 137 (2022) 47 Fulltext: PDF;

Úplný záznam - Podobné záznamy
Numerical noise due to binning in macroparticle simulations / Lasheen, Alexandre (CERN)
Numerical noise is an important parameter to minimize to ensure convergence of the macroparticle simulation results. [...]
- 2021. - 15 p.

Úplný záznam - Podobné záznamy
Challenging the Standard Model by high precision comparisons of the fundamental properties of antiprotons and protons / Borchert, Matthias Joachim
This thesis describes high precision measurements on the fundamental properties of the antiproton, namely the charge-to-mass ratio and the magnetic moment [...]
CERN-THESIS-2021-230 - Hannover : Gottfried Wilhelm Leibniz Universität, 2021-12-14.

Úplný záznam - Podobné záznamy
Chapter 3: Design of the East Area facility after renovation / Bernhard, Johannes Benedikt (CERN) ; Dogru, G (CERN) ; Evrard, S (CERN) ; Froeschl, Robert (CERN) ; Harrouch, E (CERN) ; Lazzaroni, M (CERN)
The PS primary proton beam is slowly extracted at 24 GeV/c towards the East Area with the help of the third- order resonance technique over a typical spill length of 350 to 450 ns within 2.4 s cycles. The number of East Area extractions is usually around five to six per overall PS super-cycle of typically 40 s and depends on both users and schedule constraints, respectively. [...]
2021 - 26 p. Fulltext: PDF;
In : CERN Proton Synchrotron East Area Facility, pp.17-42

Úplný záznam - Podobné záznamy
LHC procedure: excite 3 pilot bunches with AC-dipoles / Malina, Lukas ; Tomas Garcia, Rogelio (CERN)
This note summarises the pre-requisites and steps of optics measurement using AC-dipoles to excite three pilot bunches at beam energy above 4 TeV instead of a single bunch allowed previously for machine protection restrictions..
- 2020. - 2 p.

Úplný záznam - Podobné záznamy
Photostimulated desorption performance of the future circular hadron collider beam screen / González, L A (CERN) ; Baglin, V (CERN) ; Chiggiato, P (CERN) ; Garion, C (CERN) ; Kersevan, R (CERN) ; Casalbuoni, S (KIT, Karlsruhe ; European XFEL, Hamburg) ; Grau, A (KIT, Karlsruhe) ; de Jauregui, D Saez (KIT, Karlsruhe) ; Bellafont, I (CELLS - ALBA, LLS) ; Pérez, F (CELLS - ALBA, LLS)
Synchrotron radiation (SR) originated at superconducting bending magnets is known to be at the origin of several beam detrimental effects related to vacuum instabilities. One of the major challenges in the design of the vacuum beam pipes of high-energy hadron colliders is the SR coping strategy. [...]
2021 - 9 p. - Published in : Phys. Rev. Accel. Beams 24 (2021) 113201 Fulltext: PDF;

Úplný záznam - Podobné záznamy
LHC Configuration and Operational Scenario for Run 3 / Fartoukh, Stephane (CERN) ; Kostoglou, Sofia (CERN) ; Solfaroli Camillocci, Matteo (CERN) ; Arduini, Gianluigi (CERN) ; Bartosik, Hannes (CERN) ; Bracco, Chiara (CERN) ; Brodzinski, Krzysztof (CERN) ; Bruce, Roderik (CERN) ; Buffat, Xavier (CERN) ; Calviani, Marco (CERN) et al.
After its second successful run period, the Large Hadron Collider (LHC) shut down for three years with the plan of being recommissioned in 2022 for a three-year physics production period, the Run 3. [...]
- 2021. - 33 p.
Full text

Úplný záznam - Podobné záznamy